AestheFill (200mg.) Facial Wrinkle Filler

Immediately after the AestheFill procedure, it successfully adds volume to certain areas of the face (depressive areas), and establishes contraction of the skin, and then, for a year or more, due to the stimulation of the growth of the fibrous layer of the dermis, enhancement of the synthesis of elastin and collagen by fibroblasts, the skin of the face and body is rejuvenated. … The rejuvenating effect of AestheFill is based on the outstanding properties of polylactic acid. After being injected into the dermis layer, the drug, providing an instant lifting effect, rather quickly, in 3-4 months, is resorbed by the tissues of the body, but this does not mean the rapid end of its clinical effect. Polylactose acid serves as a powerful stimulator of hyaluronic acid synthesis by fibroblasts of human connective tissue. And this stimulating effect lasts for over 12 months. In this case, the body receives its own hyaluronic acid, which is synthesized exactly in the place that needs cosmetic correction.

Indications for use:

– Lipodystrophy of the face, neck, décolleté, hands;
– Depressive areas of the face (sunken cheeks, temples, nasolacrimal groove);
– Deep wrinkles and folds;
– Laxity of the skin of the face and body;
– Atrophic scars, postoperative cavities (liposuction);
– Gross asymmetry of the face;
– Increased lip volume;
– Sculpting face shapes.

Breeding method:

1. Remove the aluminum cap of the bottle, wipe its rubber stopper with an antiseptic. If the aluminum cap and rubber stopper in the vial are damaged, do not use the product.
2. Attach an 18G needle to a sterile 5 ml syringe. Draw 1.4 ml of water for injection into the syringe and slowly inject into the vial.
3. For uniform mixing of the granules with the injected water for injection, it is recommended to shake the bottle for about 10 minutes.
4. The reconstituted solution should be used immediately.
   Unused or remaining after mixing solution and vials must be disposed of.
5. Before administration, shake the reconstituted solution for better distribution of the substance.
6. Treat the rubber stopper of the bottle with an antiseptic. Use a sterile 18G needle and 1 or 3 ml syringe to collect the specimen.
7. The drug is injected using a sterile 25G needle or cannula.

Application: Product introduction should be done in a linear fashion.